Home > Return Code > Return Code 0099

Return Code 0099

S213 - 64 - AN INCORRECT OPEN OPTION WAS SPECIFIED FOR A PDSE DATA SET. Try this community option, below. S10A - 08 - NOT ENOUGH REAL STORAGE FOR SPACE IN FIXED CSA SUBPOOL. S0F9 - 00- LSQA HAS BEEN EXHAUSTED AND AN SVRB CANNOT BE CREATED TO HONOUR AN SVC REQUEST IN THE ADDRESS SPACE. weblink

If the error clears, put the cash dispenser in service. Telephone line is noisy and in general has poor quality characteristics. 3. Turn the AC power OFF for a few seconds and then back ON to power cycle and reset the cash dispenser. 3. If the error clears, put the cash dispenser in service. 5.

Verify that the DC voltages to the dispenser are correct. ASK THE OPERATOR TO REPLY 'U' OR SPECIFY ANOTHER VOLUME SERIAL. S171 - THE REAL STORAGE MANAGER WAS INVOKED WITH A REQUEST FOR A PGFIX, PGFREE, PGLOAD, OR PGOUT SERVICE AND THE REQUEST WAS ILLEGAL OR INVALID. Recommended Action: This error code is generated when a cassette is not open and any command other than open cassettes, reset, and close cassettes are sent to the system.

Restart the cash dispenser. If it clears, initiate the learn note thickness operation. ACCESS OF A PDSE BY EXCP IS NOT SUPPORTED. Clear terminal error code.

The exit sensor may be dirty. Asked by: sbagai2001From its total income, a sales company spent rs.20,000 for advertising, half of the remainder on commissions and had rs.6000 lEFT. Error Code: 141 Description: Paper jam reported by the controller during error code check. Make sure all connectors attached to the CMC are seated in their receptacles.

S306 - 20 - A JOB STEP MODULE WAS FOUND IN AN UNAUTHORIZED LNKLST LIBRARY WHEN AN APF AUTHORIZED MODULE WAS REQUIRED. S004 - THE ERROR OCCURED DURING OPEN PROCESSING USING EITHER BSAM OR QSAM BECAUSE A CONFLICTING OR INVALID DCB PARAMETER (FUNC OR RELATED PARAMETER) IS SPECIFIED. - IF THE REGISTER 15 S104 - 1C - LSQA REQUEST FAILED - PAGE TABLE PAGED OUT. TWO ENQ MACROS WERE ISSUED FOR THE SAME RESOURCE IN THE SAME TASK WITHOUT AN INTERVENING DEQ MACRO.

  1. Replace the exit sensor if defective.
  2. S237 - THE ERROR OCCURRED DURING END-OF-VOLUME LABEL VERIFICATION.
  3. S04E - INTERNAL IBM DATABASE 2 (DB2) ERROR.
  4. If the status clears and the return code are normal place the cash dispenser in service.
  5. Clear all errors and PURGE the dispenser. 4.
  6. Additionally, the Triton Connect feature may be disabled at the cash dispenser.

If the DC voltages applied to the SPED board correct and the cables are in good condition and seated properly, replace the SPED board. Complete several test dispenses. S002 - 14 - AN INVALID RECORD WAS ENCOUNTERED ON A PUT OR WRITE OPERATION. Remove any unacceptable notes from the cassette. 2.

Post interview question - assignment - to write a test plan with test cases. http://arnoldtechweb.com/return-code/scp-return-code-256.html Otherwise, the possible causes of the problem may be a defective paper low sensor, or a defective printer control PCB. Sponsored Links Related CategoriesCICS Interview QuestionsCOBOL Interview QuestionsDB2 Interview QuestionsIDMS Interview QuestionsJCL Interview QuestionsVSAM Interview Questions Open Questions Answered Open Questions Real time claims processingWhat is Claims Processing? Thanks.

S002 - 2C - THE ERROR OCCURRED WHILE OPENING AN ISAM DATASET. A PROGRAM REQUESTED VIRTUAL STORAGE THAT REQUIRES MORE REAL STORAGE THAN IS AVAILABLE. ONE OF THE FOLLOWINF OCCURRED: - A DATA EXTENT CONTROL BLOCK (DECB) WAS USED TWICE. - MULTIPLE READS OR WRITES WERE ISSUED, BUT ONLY THE LAST READ OR WRITE WAS CHECKED. http://arnoldtechweb.com/return-code/return-code-220.html If the currency is in “fit “ condition and the error persists, consider replacing the cassette or the dispenser Error Code: 34 (22h) Description: Mistracked note at feed Recommended Action: This

Physically disconnect your network cable or remove your Xbox 360 Wireless Network Adapter from the console. Recommended Action: See the recommended action for error code 144. Inspect the dispensing mechanism for jammed currency at the exit sensor.

Error Code: 157 Description: Format command to electronic journal failed.

S0E0 - 2B - AN ACCESS LIST ENTRY SPECIFIED AN INVALID DATA SPACE. The cash dispenser may be turned OFF, or the telephone line is shared with some other device that connects to the line before the cash dispenser. Error Code: 122 (7Ah) Description: Unexpected note at exit 1. Was this answer useful?Yes Reply Vijay Sep 1st, 2011 Is this a FTP job?

Error Code: 364 Description: Dispenser device offline. S013 - 2C - A SEQUENTIAL DATASET USING THE QUEUED ACCESS TECHNIQUE WITH EXCHANGE BUFFERING WAS OPENED FOR INPUT, BUT THE BUFFER CONTROL BLOCK ADDRESS WAS 0. Purge the dispensing mechanism with the PURGE command from the DIAGNOSTICS function. this content Try to inject an ID into another cassette.

S013 - E4 - THE LIMIT OF 123 EXTENTS FOR A CONCATENATED PARTITIONED DATA SET HAS BEEN EXCEEDED. (USED TO BE 256 EXTENTS?) S013 - E8 - THE OPEN VERIFICATION FUNCTION S0FD - A TYPE 6 SVC REQUESTED THE SVC FIRST LEVEL INTERRUPT HANDLER (FLIH) TO SCHEDULE A CROSS MEMORY SRB. Select Sign-in Preferences. Recommended Action: See the recommended action for error code 144.

S2F3 - JOB WAS BEING EXECUTED WHEN SYSTEM FAILURE OCCURRED - A SYSTEM RESTART WAS PERFORMED S300 - AN ERROR WAS DETECTED WHEN AN I/O OPERATION WAS REQUESTED; - EITHER THE POSSIBLE CAUSE - PREVIOUS LKED STEP FAILED TO OUTPUT A SYSLMOD, NEEDS LARGER SIZE= I/O ERROR - MACHINE TROUBLE OR DISK FAILURE S106-D - INVALID RECORD TYPE IN LOAD MODULE S106 Restart the cash dispenser. This failure may be caused by a blockage in the transport path between the Note Feeder and the note qualifier, or if a document passes through the note qualifier unseen.

Make sure the tamper screw is secure to the SPED module. Recommended Action: See the recommended action for error code 144. REPOSITIONING OR UPDATING A SPOOLED DATASET IS NOT PERMITTED. Recommended Action: This status is reported if the exit sensor is covered for a longer that allowed time for the current notes. 1.

S03B - ISAM DATASET TO BE PROCESSED, BUT NOT CREATED OR ITS DCB NOT CLOSED AFTER CREATION. S178 - 1C - LSQA REQUEST FAILED - PAGE TABLE PAGED OUT. THE CURRENT DEB TABLE DOES NOT HAVE SPACE FOR THIS NEW DEB POINTER. IE.

S113 - 30 - INVALID JCL DISPOSITION DETECTED FOR VSAM OPENED WITH A DCB. RCT RECOVERY RECORDS THE ERROR IN SYS1.LOGREC, PERFORMS RESOURCE CLEAN-UP, REQUESTS A SYS1.DUMP OF THE ADDRESS SPACE AND THEN REQUESTS ADDRESS TERMINATION. U048 - USER DOES NOT HAVE ACCESS AUTHORIZATION FOR THE DATASET U061 - REORDER DATASETS, CHECK BLOCKSIZES.